How a hacker reused the same authorization message 1,490 times to trigger massive crypto payout loops

According to the ICON Foundation, the Aug. 27 ICON replay exploit released 119,866,000 ICX and 531,600 bnUSD from foundation-held assets after two legitimate withdrawal messages were reused 1,492 times. Its Aug. 30 postmortem said 1,490 calls succeeded, while no user deposits, balances or positions were accessed.

The headline-sized ICX release is not the same as the confirmed loss. ICON put net loss to date at about 150.2 ETH plus 31,204 USDC, with the vast majority of the ICX traced, frozen and in active recovery. The foundation said bnUSD and SODA were recovered in full, but exchange-held amounts remain subject to revision. That distinction matters because ICON had not received exact exchange figures for how much ICX was held, converted or withdrawn.

Related Reading

Harmony weighs a full blockchain rollback after unauthorized minting floods exchanges with billions in ONE


The flaw let the attacker change part of a withdrawal identifier without changing the signed payload being verified. ICON traced the mismatch to a change intended to standardize withdrawal messages at 32 bytes, which routed part of the serial number through float64-range logic rather than exact integer arithmetic.

As a result, the contract’s uniqueness check looked at high bits the attacker could vary, while cryptographic verification covered the unchanged low 256 bits. The signed payload and signature remained identical within each replay set, but the altered unsigned portion made the calls appear unique. Two calls reverted; every successful call credited the same relayer wallet. ICON said the flaw was specific to its implementation because other supported chains used fixed-width integers that could not produce the same mismatch.

Related Reading

Polkadot Hyperbridge April Fools’ joke comes true as over 1 Billion fake DOT tokens were minted on Ethereum


ICON replay exploit timeline showing 1,492 replay attempts, 1,490 successful calls, the first alert, investigation, contract pause, network halt and restart.

Detection of the ICON replay exploit came before containment

ICON’s monitoring system fired at 02:08 UTC, seven minutes after the exploit began. Technical staff started investigating at about 03:40, a 92-minute gap. The affected contract was paused at 03:53, 105 minutes after the alert.

The attacker had begun splitting ICX across exchange deposit addresses at 02:44, according to ICON, and the distribution continued until about 05:20. The foundation said an ICON-side pause could not stop movement of funds already swept into exchange custody.

The network was halted at 06:18:54 and resumed at about 07:51 the next day, roughly 25 hours later. Public notices from Bitvavo, Bitget and KuCoin confirm that ICX deposits and withdrawals were suspended around the incident, though none identifies itself as holding attacker funds or verifies the amount frozen.

Related Reading

Crypto users told to pull funds after Ethereum L2 bridge failure exposes rollup exit risk


A November 2025 relay audit reviewed selected relay and verifier code, including ICON verifier files, but its published scope did not list the affected migration-contract source. None of its nine disclosed findings flagged the serial-number mismatch. ICON said incident-related relay logic had been audited, but that the gap fell outside the findings.

The post How a hacker reused the same authorization message 1,490 times to trigger massive crypto payout loops appeared first on CryptoSlate.

Total
0
Shares
Leave a Reply

Your email address will not be published. Required fields are marked *

Previous Post

Crypto treasury companies reach $340B market cap as DATs outperform traditional crypto exposure

Next Post

Optimism pushes network speeds to 200 ms, but standard data feeds are dropping key information

Related Posts